ham radio deluxe will not connect to radio

Ham Radio Deluxe (HRD) is a software that provides amateur radio operators with a method to control user`s radio hardware by computer and decode/encode digital signals on shortwave frequencies. More information on the proper use of the TRM can be found on the If you want to get fancy you can also add a PTT port in SmartSDR CAT and use RTS or DTR you choice to key the radio.Technologies must be operated and maintained in accordance with Federal and Department security and The last setup item is enabling a PTT method, via HRD which uses CAT commands is simple. Pretty simple for this example select “DAX Audio RX 1” to use the first RX Stream. Return to the “New” tab and setup the config parameters and press the connect button. On the “Serial Ports” tab of the connect window the virtual serial port presented by SmartSDR CAT is visable.

Next let’s start up HRD and setup the CAT connection to the radio. In the DAX Control Panel one final step before moving on, enable “RX Stream 1” by clicking on the “1” which will change the stream to active and the indicator to blue. I have outlined in red below the key configuration areas.

In my example below I am running a 5Khz wide slice which while in the example is on a 20 meters PSK frequency, this setup works well across any of the audio based digital modes.įor DAX to work it must be enabled, the slice assigned a DAX channel, it is also a best practice to open up the receiver width to 5k with a corresponding change to the TX High Cut to match. Since we are going through the effort of plumbing up the CAT connection, let us spend a little time setting up the virtual sound card for whatever tickles your fancy. The connection will not actually occur until HRD config is complete. Also shown in the screen capture below, HRD is connected to this port.

Below is the end result a Com11 CAT serial port assigned to Slice A. So I thought it a worthwhile use of time to create a similar posting for SmartSDR.Īs the FlexRadio documentation is excellent I will not spend much if any time providing details on how for example to create a port in SmartSDR CAT as the existing user documentation covers this in detail.įirst step is setting up a vitual serial port for HRD to connect to. My post covering the setup and use of the Yaesu FTdx3000 with Ham Radio Deluxe (HRD) gets hundreds of hits a week.

Ham radio deluxe will not connect to radio